MegaMouth v2.0 MegaMouth® Reels' Elite Series Bowfishing Line 200# 40 Yards #MM7204

MegaMouth v2.0 MegaMouth® Reels' Elite Series Bowfishing Line 200# 40 Yards #MM7204

For v2.0 MegaMouth® reels: Always make sure to have plenty of extra line in the boat so that your next bowfishing adventure doesn’t stop short. This line is already wound on the custom line spool for v2.0 MegaMouth® reels. Simply swap out your old spool, reassemble and you’re ready to keep shooting fish. This will not work with the Original MegaMouth® reels.

This spool is only compatible with the v2.0 MegaMouth®. A v2.0 reel will be clearly marked with a 2.0 near the logo on the outer cone of the reel. If the cone is not marked it will be considered an Original. Otherwise, remove the front assembly and check which bearing you have. A brass bearing indicates a v2.0 reel while a steel and black bearing indicate the Original Reel.

**Installs on the following MegaMouth® Reel models: #9020 & #9500

Replacement Instructions:

1. Remove the hex set torque rod by loosening the thumb screws on the front of the picatinny tube and pull torque rod out.
2. Twist cone counterclockwise and pull to remove.
3. Unthread front end cap nut counterclockwise.
4. Pull off the front line deflector being careful to retain all 3 springs.
5. Remove the front transmission e-clip by hand or with a pliers.
6. Pull off the rear line deflector.
7. Remove the entire spool of line and bearing.
8. Remove the old bearing from the old line spool and reuse.
9. Insert old bearing into new line spool.
10. Install new line spool with the grooved bottom side down and the smooth surface up.